Where does the waste go?

Three places: kerf, trim and offcuts. In the bookcase example, kerf is 1.0% of the sheet and offcuts are 31.6%. Leftovers matter far more than the blade for that job.

What helps in practice?

  • Measure the usable stock instead of using a label size.
  • Allow rotation only where the design allows, since a turn can change what fits.
  • Group parts by material and thickness before planning.
  • Change a part by a few millimetres if the design allows, then re-run the plan.
  • Keep offcuts you can use and write their size down. See offcut inventory.

Will an optimizer remove all waste?

No. Rectangles rarely fill a rectangle exactly. Kerflio does not claim a savings percentage.

Frequently asked questions

Should I add a waste percentage? Not to the kerf field. Kerf and waste are different. See saw kerf explained.

Related: How many sheets · Grain and rotation · Sheet planner

How this page was made: written by Certloom Learning from the Kerflio planning engine and the arithmetic shown. Not reviewed by a tradesperson. Check your own material and equipment.