How do I measure kerf with a test cut?

  1. Measure a straight offcut of the same material. Say it reads 600.0 mm.
  2. Make one cut across it.
  3. Measure both pieces. Say you get 298.4 and 298.6 mm.
  4. Subtract: 600.0 − 298.4 − 298.6 = 3.0 mm.

That 3.0 mm is the kerf for that cut. Repeat once more to see if it stays the same.

What about a more accurate result?

Make several cuts in one piece and divide the total missing length by the number of cuts. Averaging reduces the effect of a single measuring slip. Use a rule or caliper you trust and measure in the same way each time.

What number do I enter?

The kerf you measured for your setup. A blade datasheet may give a nominal cut width, and your saw may cut slightly wider. If you have not measured, use the manufacturer's figure as a starting point and verify. The 3 mm default in this website's planners is an example.

What happens if I enter too small a kerf?

A close fit may show as placed on screen and then fail at the saw. If you enter too large a kerf, a part can show as unplaced although it would have fit. Recalculate after you change it. See saw kerf explained.

Frequently asked questions

Is kerf the same as waste? Kerf is one kind of waste. Offcuts and trim are separate, and the kerf note explains the difference.

Does a track saw cut a different kerf? It can. Measure for each tool and blade.

Related: Linear planner · Make a cut list · Reduce waste

How this page was made: written by Certloom Learning from the Kerflio planning engine and the arithmetic shown. Not reviewed by a tradesperson. Check your own material and equipment.