What is the cut list?

Pine boards 19 × 89 mm, lengths in millimetres, 3 mm kerf
PartLengthQty
Slat1,2005
Leg4304
Brace3502

Total length: 5 × 1,200 + 4 × 430 + 2 × 350 = 8,420 mm. That is 3.5 boards of 2,400 mm.

Why does the plan need five boards?

Two slats cut from one board need 1,200 + 3 + 1,200 = 2,403 mm. The board is 2,400 mm, so only one slat fits per board with a separating cut. Each slat takes its own board. Kerflio's plan: boards 1 and 2 hold a slat and two legs, board 3 a slat and two braces, boards 4 and 5 one slat each.

With four boards, Kerflio places 10 of 11 pieces and lists the last as unplaced.

How much is left over?

Five boards are 12,000 mm. Parts use 8,420 mm, kerf 33 mm over 11 cuts, and 3,547 mm remains as five offcuts (331, 331, 491, 1,197 and 1,197 mm). Two 1,197 mm offcuts are 3 mm short of a slat, so they cannot replace one.

Shorten the slats by 3 mm, or buy 2,403 mm or longer stock, and the arithmetic changes. Run it in the linear planner.

Frequently asked questions

Is the last cut counted when a piece ends at the board end? No. That cut is not needed.

Related: Actual lumber sizes · Measure kerf · Sheet vs linear

How this page was made: written by Certloom Learning from the Kerflio planning engine and the arithmetic shown. Not reviewed by a tradesperson. Check your own material and equipment.