How do the two modes compare?
| Sheet mode | Linear mode | |
|---|---|---|
| Stock | Panels with a length and a width | Boards of one cross section and a length |
| Parts | Rectangles | Lengths |
| Cuts | Edge-to-edge in two directions | Across the board |
| Rotation | Optional quarter turn | Not applicable |
| Typical jobs | Cabinets, shelves, panels | Frames, trim, rails, decking |
When should I use the sheet planner?
Plywood, MDF, melamine and other panels. Open the sheet cut planner. Read grain and rotation first if the face pattern matters.
When should I use the linear planner?
Matching boards where you only cut to length. Open the linear cut planner. It does not rip a board to a narrower width.
What if I have both?
Plan them as separate jobs. A cabinet with a plywood carcass and solid-wood face frame is two plans.
Frequently asked questions
Can a board be planned as a narrow sheet? Only if you also need width cuts. Otherwise linear mode is clearer.
Related: What an optimizer does · Board example · Sheet example
How this page was made: written by Certloom Learning from the Kerflio planning engine and the arithmetic shown. Not reviewed by a tradesperson. Check your own material and equipment.