What is a guillotine cut?

Start with a sheet. Cut it in two with a straight line from edge to edge. Take each half and do the same. If you can reach every part this way, the layout is guillotine. Kerflio's cut walkthrough lists the parent cut before the cuts inside it.

What is a layout that is not guillotine?

Imagine a pinwheel of four rectangles around a central one. No single edge-to-edge line separates them without crossing a part. Such layouts can pack tighter on a CNC router, but are awkward on a saw. Kerflio does not produce them.

Why accept the limit?

A plan you can cut in a clear order is easier to follow and to check. The cost is that a few jobs could use slightly less material with a freer layout. See the methodology.

How do I read the cut order?

Step 1 is the first full-length cut. Later steps work inside the pieces it created. This is geometry only. It is not saw operating advice.

Frequently asked questions

Does guillotine mean waste? Not necessarily. It restricts the arrangement, so a freer layout can sometimes use less.

Related: Optimizer explained · Sheet planner

How this page was made: written by Certloom Learning from the Kerflio planning engine and the arithmetic shown. Not reviewed by a tradesperson. Check your own material and equipment.